Power analysis (option R&S RTE-K31)
R&S
®
RTE
958User Manual 1326.1032.02 ─ 20
Activate user defined preset
If enabled, the deskew values are written to a user-defined preset file, and the user-
defined preset is enabled. Thus, the probe setup and deskew values are not influenced
by a manual [PRESET].
See also: Chapter 12.6, "Preset setup", on page 509.
Remote command:
POWer:DESKew:UDPReset on page 1945
Auto Deskew
Starts an auto deskew.
Make sure that the probes are configured correctly before you start the deskewing.
Remote command:
POWer:DESKew:EXECute on page 1945
16.1.1.2 DUT
Access: "Analysis" > "Power" > "DUT".
In this dialog, you can describe your device under test (DUT). The information set in
this dialog can be used on the title page for a report generated from the "Power Analy-
sis" measurements, see "Content" on page 963.
Device under test (DUT)
Enter a name for your DUT.
Remote command:
POWer:REPort:DUT on page 1947
User
Enter a user.
Remote command:
POWer:REPort:USER on page 1947
Power measurement selection
To Next Page
Loading...
