Rohde & Schwarz RTE - Control Loop; Modulation Analysis

Power analysis (option R&S RTE-K31)
R&S
®
RTE
980User Manual 1326.1032.02 ─ 20
Revised Current
Available only for "Standard" > "RTCA DO-160".
Selects how the results are evaluated. Available are the following settings:
●
Evaluation with current source only
●
Evaluation with voltage source and revised current law
– Display opposite voltage harmonic result chart
– Do not display voltage result
Remote command:
POWer:HARMonics:EVAL on page 1956
POWer:HARMonics:VOLT on page 1957
Optimize scaling
Selects the scaling for the display of the results.
"Autoscale the signals"
Automatically selects the most appropriate scale for the display of the
results.
"Keep present settings"
The present display settings are not changed.
Remote command:
POWer:HARMonics:AUTO on page 1955
Report comment
In this field you can write a comment that is displayed in the measurement report, for
example, a measurement description.
Execute
Starts the "Current Harmonics" measurement.
Remote command:
POWer:HARMonics:EXECute on page 1956
16.4 Control loop
The "Control Loop" measurements are used for characterizing the switching properties
of a device.
16.4.1 Modulation analysis
The "Modulation Analysis " measures the control pulse signal to a switching device.
Required probes:
●
Differential voltage probe
●
Current probe
Control loop