Protocol analysis
R&S
®
RTE
585User Manual 1326.1032.02 ─ 20
Remote commands
Remote commands are described in Chapter 18.17.6.3, "Decode results",
on page 1500.
13.5.6 Search on decoded CAN or CAN FD data
Using the search functionality, you can find various events in the decoded data. You
can find the same events that you can trigger on, and even many more, since several
event types can also be combined.
Before you can start the search, you have to configure the bus correctly and acquire
decoded data.
To search on decoded data, set the search source to "SerBus" for the configured proto-
col.
For general information on how to handle the search functionality, see Chapter 11,
"Search functions", on page 445.
13.5.6.1 Search settings
Access: [SEARCH] > "Setup" tab
Search Criteria
Sets one criterion or an AND-combination of criteria to be searched for. If more than
one criterion is selected, all criteria must be fulfilled by a frame for it to be shown in the
search results.
CAN and CAN FD (option R&S
RTE-K3/K9)
To Next Page
Loading...
