Rohde & Schwarz RTE - Preset Setup; User-Defined Preset - Settings

Data and file management
R&S
®
RTE
509User Manual 1326.1032.02 ─ 20
Show Preview
Opens the current report in PDF format.
User name / Comment
Enter information that appears in the general information section at the beginning of
the report.
Remote command:
REPort:USER on page 1418
REPort:COMMent on page 1419
Logo
By default, the Rohde & Schwarz logo is shown in the header of the report pages. You
can switch the logo off, or select your logo to be shown. A preview of the selected log
file is shown.
Remote command:
REPort:LOGType on page 1418
REPort:LOGO on page 1418
Save to file
Select the file format and define the filename of the report file. By default, the filename
has the prefix "Report_".
Double-tap the filename to open the file selection dialog box.
"pdf/doc/html"
Selects the report format.
"Save"
Saves the current report to the specified file.
"Save As..."
Opens the file selection dialog box and saves the report to the
selected file.
Remote command:
REPort:FILE:NAME on page 1419
REPort:FILE:SAVE on page 1419
Print
Starts the printout to the configured printer.
12.6 Preset setup
A user-defined preset contains the complete instrument setup including display set-
tings, except for transparency and intensity. You can save the current configuration to a
preset file, and load a previously saved preset file. You can then specify that these set-
tings are to be applied with the [PRESET] key.
12.6.1 User-defined preset - settings
Access: "File" menu > "Preset setup"
Preset setup