Data and file management
R&S
®
RTE
501User Manual 1326.1032.02 ─ 20
12.3.2 Defining default file paths and names
When a save or load operation is performed, a default file name and path is provided.
You can configure which path is used and how the file name is generated. In the file
selection dialog box, you can change the folder and name as desired.
To define the default file path
1. Press the [FILE] key.
2. Select the "Save" tab.
3. Select the "Autonaming" tab.
4. Double-tap the "Default path for all file operations" field.
The directory selection dialog box is opened.
5. Select the folder in which the data is stored by default. Use the symbols on the left
of the file explorer box to switch to often used directories.
6. To restore the factory-set default path, tap "Reset" next to the path field.
To define the automatic file name pattern
The automatic file name pattern can consist of the following elements:
<Prefix>_<UserText>_<Date>_<Index>_<Time>
The prefix depends on the data type to be stored and cannot be changed by the user.
The other elements can be enabled or disabled as required.
1. Press the [FILE] key.
2. Select the "Save" tab.
3. Select the "Autonaming" tab.
4. To insert a user-defined text after the prefix, enter the text in the edit field. and
enable "User text".
5. If you want to exclude the prefix, current date, time or an index (serial number), dis-
able the corresponding option.
The specified elements are used to generate the default file name for the next stor-
age operation.
12.4 Screenshots
To store the graphical results of the measurement, you can save a screenshot of the
graphic area. To document current settings, the open dialog box can be included in the
screenshot.
You can also print the image directly to a printer.
Screenshots
To Next Page
Loading...
