Rohde & Schwarz RTE - Search

Remote control commands
R&S
®
RTE
1351User Manual 1326.1032.02 ─ 20
MTESt:RESult:FRATe? <MaskTestName>
Ratio of acquisition hits to the number of tested acquisitions.
Query parameters:
<MaskTestName>
Return values:
<FailRate> Range: -100E+24 to 100E+24
*RST: 0
Default unit: %
Usage: Query only
Asynchronous command
18.15
Search
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 18.3, "Programming examples", on page 1054
● General search settings...................................................................................... 1352
● Basic trigger search conditions........................................................................... 1353
● Edge search conditions.......................................................................................1356
● Glitch search conditions......................................................................................1356
● Interval search conditions................................................................................... 1357
● Runt search conditions........................................................................................1359
● Slew rate search conditions................................................................................ 1361
● Timeout search conditions.................................................................................. 1364
● Width search conditions......................................................................................1364
● Window search conditions.................................................................................. 1366
● Data2Clock search conditions.............................................................................1369
● Pattern search conditions....................................................................................1371
● State search conditions.......................................................................................1375
● Search on spectrum............................................................................................1378
● Search gate settings........................................................................................... 1379
● Noise rejection.................................................................................................... 1382
● Search results..................................................................................................... 1384
Search