Rohde & Schwarz RTE - Page 1350

Remote control commands
R&S
®
RTE
1350User Manual 1326.1032.02 ─ 20
Return values:
<AcqsCompleted> Range: 0 to 100E+24
*RST: 0
Usage: Query only
Asynchronous command
MTESt:RESult:COUNt:REMaining? <MaskTestName>
Remaining acquisitions until "Average count / Nx Single count" is reached.
The value is useful if you test a specified number of acquisitions with action "Stop
acquisition" on violation, or if the acquisition has been stopped manually.
See also: Chapter 10.3.4, "Running a mask test", on page 442.
Query parameters:
<MaskTestName>
Return values:
<AcqsRemaining> Range: 0 to 100E+24
*RST: 0
Usage: Query only
Asynchronous command
MTESt:RESult:COUNt:FWAVeforms? <MaskTestName>
Returns the number of acquisitions that contained at least one sample hit.
Query parameters:
<MaskTestName>
Return values:
<AcquisitionHits> Range: 0 to 100E+24
*RST: 0
Usage: Query only
Asynchronous command
MTESt:RESult:COUNt:FAILures? <MaskTestName>
Returns the number of sample hits that violated the mask.
Query parameters:
<MaskTestName>
Return values:
<SampleHits> Range: 0 to 100E+24
*RST: 0
Usage: Query only
Asynchronous command
Mask testing