Rohde & Schwarz RTE - FSK Modulation

Waveform generator (Option R&S RTE-B6)
R&S
®
RTE
935User Manual 1326.1032.02 ─ 20
Modulation signal
Selects the type of the modulation signal for the FM modulation types.
Remote command:
WGENerator<m>:MODulation:FM[:FUNCtion] on page 1929
Modulation freq
Sets the frequency of the modulation waveform.
Remote command:
WGENerator<m>:MODulation:FM:FREQuency on page 1929
Symmetry
Sets the symmetry for the ramp modulation waveform, the percentage of time that the
waveform is rising.
Remote command:
WGENerator<m>:MODulation:FM:SYMMetry on page 1929
Freq deviation
Sets the frequency deviation, the maximum difference between and FM modulated sig-
nal and the carrier signal.
Remote command:
WGENerator<m>:MODulation:FM:DEViation on page 1928
Duty cycle
Sets the duty cycle for a square waveform. The duty cycle expresses the percentage of
the period during which the waveform is active, i.e. the signal state is high.
Remote command:
WGENerator<m>:MODulation:FM:DCYCle on page 1928
15.1.3.5 FSK modulation
For frequency shift keying (FSK) modulation, the signal switches between Frequency 1
and Frequency 2 at a Hop rate.
Setup of the waveform generator