Rohde & Schwarz RTE - Edge Search Conditions; Glitch Search Conditions

Remote control commands
R&S
®
RTE
1356User Manual 1326.1032.02 ─ 20
Setting parameters:
<SearchName> String with name of the search
Usage: Setting only
Asynchronous command
18.15.3 Edge search conditions
Trigger level setting: SEARch:TRIGger:LEVel[:VALue] on page 1355
SEARch:TRIGger:EDGE:SLOPe................................................................................... 1356
SEARch:TRIGger:EDGE:SLOPe <SearchName>,<Slope>
SEARch:TRIGger:EDGE:SLOPe? <SearchName>
Selects the edge type.
Parameters:
<Slope> POSitive | NEGative | EITHer
See Chapter 18.4.3, "Slope parameter", on page 1075.
*RST: POSitive
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
18.15.4 Glitch search conditions
Trigger level setting: SEARch:TRIGger:LEVel[:VALue] on page 1355
SEARch:TRIGger:GLITch:POLarity................................................................................1356
SEARch:TRIGger:GLITch:RANGe................................................................................. 1357
SEARch:TRIGger:GLITch:WIDTh...................................................................................1357
SEARch:TRIGger:GLITch:POLarity <SearchName>,<Polarity>
SEARch:TRIGger:GLITch:POLarity? <SearchName>
Indicates the polarity of a pulse, that is the direction of the first pulse slope.
Parameters:
<Polarity> POSitive | NEGative | EITHer
See Chapter 18.4.4, "Polarity parameter", on page 1075.
*RST: POSitive
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
Search