Rohde & Schwarz RTE - Glitch; Width

Search functions
R&S
®
RTE
451User Manual 1326.1032.02 ─ 20
Remote command:
SEARch:TRIGger:LEVel[:VALue] on page 1355
11.2.2.2 Glitch
The glitch search works the same way as the glitch trigger. To apply the trigger settings
to search, tap Copy 'A Trigger'.
The glitch search is not available if the search source is a digital channel.
Polarity, Range, Width
See trigger settings:
●
"Range" on page 245
●
"Width" on page 245
●
"Polarity" on page 245
Remote command:
SEARch:TRIGger:GLITch:POLarity on page 1356
SEARch:TRIGger:GLITch:RANGe on page 1357
SEARch:TRIGger:GLITch:WIDTh on page 1357
Trigger level
Sets the voltage level for trigger search. The value is used for all search event types
that require one trigger level. The search trigger level is search-specific, you can define
different levels in different searches for the same event.
Remote command:
SEARch:TRIGger:LEVel[:VALue] on page 1355
11.2.2.3 Width
The width search works the same way as the width trigger. To apply the trigger settings
to search, tap Copy 'A Trigger'.
Search setup