Power analysis (option R&S RTE-K31)
R&S
®
RTE
965User Manual 1326.1032.02 ─ 20
16.2.1 Channels tab
In the "Channels" tab, you find information on the experimental setup of the selected
power measurement. A short description explains what probes are needed and how to
connect them. The description is supported by a block diagram of the experimental
setup that shows the connection points for the probes.
Depending on the selected power measurement, one or two voltage sources and cur-
rent sources are required.
Current Source
Sets the channel for the current source.
Remote command:
POWer:SOURce:CURRent<1..2> on page 1944
Voltage Source
Sets the channel for the voltage source input.
Remote command:
POWer:SOURce:VOLTage<1..4> on page 1944
16.2.2 Settings tab
In the "Settings" tab, you configure the measurement and display settings. The settings
depend on the selected power measurement.
Overview of power measurement setup
To Next Page
Loading...
