Data and file management
R&S
®
RTE
510User Manual 1326.1032.02 ─ 20
Preset
Performs a user-defined preset of the instrument.
Save to or load from file
The file name with extension .dfl to load or to save the settings to.
For details, see .Chapter 12.7, "File selection dialog", on page 511.
Enable user defined preset
If enabled, the settings from the selected preset file are restored when the [PRESET]
key is pressed.
If disabled, [PRESET] sets the instrument to the factory defaults.
Factory defaults
Resets the instrument to the factory default settings, to the initial state. Factory settings
comprise all instrument settings, including display, intensity and transparency settings.
After loading factory defaults, perform a self-alignment to synchronize the signal data.
Remote command:
SYSTem:PRESet on page 1086
12.6.2 Restoring settings
When you have changed many different settings on the instrument and are no longer
sure which settings are causing which effect in the measurement, you may want to
restore the default settings and start anew. The following methods are available:
●
Saving instrument settings to a user-defined preset and restoring the instrument
settings to user-defined default values
●
Restoring all settings on the R&S RTE to the factory-defined values
●
Restoring settings from a file (see "To load settings from a saveset file"
on page 476)
Preset setup
To Next Page
Loading...
