Rohde & Schwarz RTE - Decode Results

Remote control commands
R&S
®
RTE
1434User Manual 1326.1032.02 ─ 20
TRIGger<m>:I2C:DMIN <Data>
Specifies the data bit pattern, or sets the the start value of a data pattern range.. Enter
the bytes in msb first bit order. The maximum pattern length is 64 bit. Waveform data is
compared with the pattern byte-by-byte.
Parameters:
<Data> Numeric or string pattern, see Chapter 18.4.6, "Bit pattern
parameter", on page 1076. The string parameter accepts the bit
value X (don't care).
Usage: Asynchronous command
TRIGger<m>:I2C:DMAX
<DataTo>
Sets the the end value of an data range if TRIGger<m>:I2C:DCONdition is set to
INRange or OORange.
Parameters:
<DataTo> Numeric or string pattern, see Chapter 18.4.6, "Bit pattern
parameter", on page 1076. The string parameter accepts the bit
value X (don't care).
Usage: Asynchronous command
18.17.3.3 Decode results
To load and acivate a label list, use:
●
BUS<m>:NEWList on page 1422
●
BUS<m>:SYMBols on page 1423
BUS<m>:I2C:FRAMe<n>:DATA?...................................................................................1435
BUS<m>:I2C:FCOunt?................................................................................................. 1435
BUS<m>:I2C:FRAMe<n>:AACCess?.............................................................................1435
BUS<m>:I2C:FRAMe<n>:ACCess?............................................................................... 1436
BUS<m>:I2C:FRAMe<n>:ACOMplete?.......................................................................... 1436
BUS<m>:I2C:FRAMe<n>:ADBStart?............................................................................. 1436
BUS<m>:I2C:FRAMe<n>:ADDRess?.............................................................................1437
BUS<m>:I2C:FRAMe<n>:ADEVice?..............................................................................1437
BUS<m>:I2C:FRAMe<n>:AMODe?............................................................................... 1437
BUS<m>:I2C:FRAMe<n>:ASTart?................................................................................. 1438
BUS<m>:I2C:FRAMe<n>:BITRate?............................................................................... 1438
BUS<m>:I2C:FRAMe<n>:RWBStart?.............................................................................1438
BUS<m>:I2C:FRAMe<n>:STATus?................................................................................1439
BUS<m>:I2C:FRAMe<n>:STARt?..................................................................................1439
BUS<m>:I2C:FRAMe<n>:STOP?.................................................................................. 1440
BUS<m>:I2C:FRAMe<n>:SYMBol?............................................................................... 1440
BUS<m>:I2C:FRAMe<n>:BCOunt?............................................................................... 1440
BUS<m>:I2C:FRAMe<n>:BYTE<o>:ACCess?................................................................ 1441
BUS<m>:I2C:FRAMe<n>:BYTE<o>:ACKStart?...............................................................1441
Protocols