Rohde & Schwarz RTE - Display

Remote control commands
R&S
®
RTE
1287User Manual 1326.1032.02 ─ 20
Parameters:
<UpperMargin> Range: -100 to 100
Increment: 10E-6
*RST: 0
Usage: Asynchronous command
18.12.7 Display
MEASurement<m>:DISPlay:LEVels............................................................................... 1287
MEASurement<m>:DISPlay:RESults..............................................................................1287
MEASurement<m>:DISPlay:STYLe............................................................................... 1288
MEASurement<m>:DISPlay:HISTogram.........................................................................1288
DISPlay:RESultboxes:MEPosition..................................................................................1288
MEASurement<m>:DISPlay:LEVels <DisplayLevels>
If enabled, the reference levels used for the measurement are displayed in the dia-
gram.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<DisplayLevels> ON | OFF
*RST: OFF
Usage: Asynchronous command
MEASurement<m>:DISPlay:RESults <DisplayResult>
If enabled, the intermediate result linesare displayed in the measurement diagram.
Result lines mark the samples in the waveform that are used to obtain the measure-
ment result. These are, for example, maximum and minimum values, mean, cycle start
and cycle end, and others.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<DisplayResult> ON | OFF
*RST: OFF
Usage: Asynchronous command
Automatic measurements