Remote control commands
R&S
®
RTE
1993User Manual 1326.1032.02 ─ 20
TRACe:REMote:MODE:FILE:FUNCtions <Enable>
Enables and disables output of function names to remote trace.
Parameters:
<Enable> ON | OFF
18.24 Deprecated commands
The following commands are provided for compatibility to previous oscilloscope ver-
sions only. For new remote control programs, use the specified alternative commands.
18.24.1 Base instrument
Legacy command Replaced by Comment
ACQuire:ARESet:WFMCount ACQuire:ARESet:COUNt on page 1962 Replaced since FW 2.70
BUSFormat For parallel buses:
BUS<m>:PARallel:DATA:FORMat
on page 1907
For serial buses:
BUS<m>:FORMat on page 1422
Replaced since FW 4.70
MEASurement<m>:SPECtrum:NREJect
Functionality is not supported.
MEASurement<m>:SPECtrum:THReshold MEASurement<m>:SPECtrum:ATHReshold
on page 1272
Replaced since FW 3.30
SEARch:TRIGger:INTerval:POLarity SEARch:TRIGger:INTerval:SLOPe
on page 1357
Replaced since FW 2.70
SYSTem:RESet *RST on page 1080 Replaced since FW 4.60
TRIGger<m>:INTerval:POLarity TRIGger<m>:INTerval:SLOPe
on page 1179
Replaced since FW 2.70
Deprecated commands
To Next Page
Loading...
