Rohde & Schwarz RTE - Noise Rejection

Remote control commands
R&S
®
RTE
1382User Manual 1326.1032.02 ─ 20
Example: Prerequisite: Search1 and Zoom2 are available.
SEARch:GATE:ZCOupling 'Search1',ON
SEARch:GATE:ZDIagram 'Search1','Diagram1','Zoom2'
SEARch:GATE:ZDIagram? 'Search1'
<-- Diagram1;Zoom2
SEARch:GATE:STATe 'Search1', ON
SEARch:GATE:SHOW 'Search2', ON
Enables the zoom coupling to define the gate,and selects
Zoom2 as gate area. Zoom2 is based on Diagram1. Then the
gate is activated and displayed.
Usage: Asynchronous command
18.15.16
Noise rejection
SEARch:TRIGger:LEVel:NOISe:ABSolute...................................................................... 1382
SEARch:TRIGger:LEVel:NOISe:MODE.......................................................................... 1382
SEARch:TRIGger:LEVel:NOISe:RELative.......................................................................1383
SEARch:TRIGger:LEVel:NOISe[:STATe].........................................................................1383
SEARch:TRIGger:LEVel:NOISe:ABSolute <SearchName>, <SignalSource>,
<Value>
Defines the trigger hysteresis, a range in absolute values around the trigger level. If the
signal jitters inside this range and crosses the trigger level, no trigger event is detected.
Parameters:
<Value> Hysteresis value
Setting parameters:
<SearchName> String with the name of the search
<SignalSource> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 |
D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15 | TRK1 | TRK2 |
TRK3 | TRK4 | TRK5 | TRK6 | TRK7 | TRK8 | Z1V1 | Z1V2 |
Z1V3 | Z1V4 | Z1I1 | Z1I2 | Z1I3 | Z1I4 | Z2V1 | Z2V2 | Z2V3 |
Z2V4 | Z2I1 | Z2I2 | Z2I3 | Z2I4
Source of the search, see Chapter 18.4.2, "Waveform parame-
ter", on page 1074
Usage: Asynchronous command
SEARch:TRIGger:LEVel:NOISe:MODE <SearchName>, <SignalSource>, <Mode>
SEARch:TRIGger:LEVel:NOISe:MODE? <Key>, <SignalSource>
Defines whether absolute values or relative values to the vertical scaling are used as a
hysteresis for noise rejection.
Parameters:
<Mode> ABS | REL
Search