Rohde & Schwarz RTE - Coupling and Sync Settings

Waveform generator (Option R&S RTE-B6)
R&S
®
RTE
947User Manual 1326.1032.02 ─ 20
Preset Gen1/Gen2/Patt Gen
Sets the parameters of the generator to their default values. The settings of the gener-
ators are not affected by an instrument preset.They are also not stored in the user-
defined preset.
Remote command:
WGENerator<m>:PRESet on page 1923
PGENerator:PRESet on page 1937
15.3 Coupling and Sync settings
Access: [Gen 1]/[Gen 2] > "Coupling & Sync" tab.
In the R&S RTE, you can couple certain settings of the available waveform generators.
If one of the available coupling options is enabled for one of the generators, then you
cannot change the coupled parameters at the "Setup" tab of the other generator. The
values for all coupled parameters are automatically taken from the currently selected
generator.
Couple all parameters except inversion and load
Couples all signal, output and noise parameters of "Gen1" to "Gen2" or "Gen2" to
"Gen1", except for output enabling, "Load" and "Inversion". The values are taken from
the currently selected generator.
Remote command:
WGENerator<m>:COUPling:ALL on page 1941
Couple all parameters (including output enable) except inversion and load
Couples all signal, output and noise parameters of "Gen1" to "Gen2" or "Gen2" to
"Gen1", including the output enabling, but excluding "Load" and "Inversion". The set-
ting is useful for the generation of differential signals. The values are taken from the
currently selected generator.
Coupling and Sync settings