Rohde & Schwarz RTE - Search Results

Protocol analysis
R&S
®
RTE
590User Manual 1326.1032.02 ─ 20
Remote command:
SEARch:TRIGger:CAN:CRCerror on page 1516
SEARch:TRIGger:CAN:BITSterror on page 1516
SEARch:TRIGger:CAN:FORMerror on page 1517
SEARch:TRIGger:CAN:ACKerror on page 1516
SEARch:TRIGger:CAN:FDATa:SCERror on page 1517
13.5.6.2 Search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
The "Show search zoom windows" function allows you to analyze the search results in
more detail. Search zoom and result table are synchronized; if you select a row in the
result table, this result is shown in the search zoom.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 446
●
Chapter 11.4, "Result presentation", on page 463
Remote commands:
●
SEARch:RESult:CAN:FCOunt? on page 1519
●
SEARch:RESult:CAN:FRAMe<m>:STATus? on page 1523
●
SEARch:RESult:CAN:FRAMe<m>:FERCause? on page 1521
●
SEARch:RESult:CAN:FRAMe<m>:ACKState? on page 1520
●
SEARch:RESult:CAN:FRAMe<m>:ACKValue? on page 1519
●
SEARch:RESult:CAN:FRAMe<m>:BSEPosition? on page 1519
●
SEARch:RESult:CAN:FRAMe<m>:BYTE<n>:STATe? on page 1519
●
SEARch:RESult:CAN:FRAMe<m>:BYTE<n>:VALue? on page 1520
●
SEARch:RESult:CAN:FRAMe<m>:CSSTate? on page 1520
●
SEARch:RESult:CAN:FRAMe<m>:CSValue? on page 1520
●
SEARch:RESult:CAN:FRAMe<m>:DATA? on page 1521
●
SEARch:RESult:CAN:FRAMe<m>:DLCState? on page 1520
CAN and CAN FD (option R&S
RTE-K3/K9)