Remote control commands
R&S
®
RTE
1075User Manual 1326.1032.02 ─ 20
Waveform Description
SG1TL1, SG1TL2, SG2TL1, SG2TL2, SG3TL1,
SG3TL2, SG4TL1, SG4TL2
Spectrograms (option R&S RTE-K18)
Z1V1 | Z1V2 | Z1V3 | Z1V4 | Z1I1 | Z1I2 | Z1I3 |
Z1I4 | Z2V1 | Z2V2 | Z2V3 | Z2V4 | Z2I1 | Z2I2 |
Z2I3 | Z2I4
Z1V1 | Z1V2 | Z1I1 | Z1I2 | Z2V1 | Z2V2 | Z2I1 |
Z2I2
Input channels of multi-channel probe R&S RT-
ZVC04
Input channels of multi-channel probe R&S RT-
ZVC02
18.4.3 Slope parameter
The slope parameter is used with several trigger and search condition commands.
Slope Description
POSitive Rising edge, that is a positive voltage change.
NEGative Falling edge, that is a negative voltage change
EITHer rising as well as the falling edge.
18.4.4 Polarity parameter
The polarity parameter is used with several trigger and search condition commands.
Polarity Description
POSitive Positive going pulses.
NEGative Negative going pulses.
EITHer Both positive and negative going pulses.
18.4.5 Event parameter
The event parameter is used with commands defining an action for mask testing, limit
checks and margin checks.
Event Description
NOACtion The action is not initiated.
SUCCess
The action is initiated if the operation finished successfully:
●
Limits or margins were not exceeded during the entire measurement
●
Mask test passed
VIOLation
The action is initiated if the operation finished with error:
●
Limits or margins were violated during the measurement
●
Mask test failed
Frequently used parameters and suffixes
To Next Page
Loading...
