Rohde & Schwarz RTE - Configuration; CXPI (Option R&S RTE-K76)

Remote control commands
R&S
®
RTE
1873User Manual 1326.1032.02 ─ 20
Usage: Query only
18.17.20 CXPI (option R&S RTE-K76)
● Configuration.......................................................................................................1873
● Trigger.................................................................................................................1876
● Decode results.................................................................................................... 1885
● Search settings................................................................................................... 1888
● Search result settings..........................................................................................1897
18.17.20.1 Configuration
BUS<m>:CXPI:BITRate:ENABle....................................................................................1873
BUS<m>:CXPI:BITRate:VALue..................................................................................... 1873
BUS<m>:CXPI:RESult:BITRate?................................................................................... 1874
BUS<m>:CXPI:DORD.................................................................................................. 1874
BUS<m>:CXPI:HYSTeresis...........................................................................................1874
BUS<m>:CXPI:POLarity............................................................................................... 1874
BUS<m>:CXPI:THReshold............................................................................................1875
BUS<m>:CXPI:SDATa..................................................................................................1875
BUS<m>:CXPI:IBS:MAX...............................................................................................1875
BUS<m>:CXPI:IBS:MIN................................................................................................1876
BUS<m>:CXPI:IFS:MAX...............................................................................................1876
BUS<m>:CXPI:IFS:MIN................................................................................................1876
BUS<m>:CXPI:BITRate:ENABle <BitrateEnable>
Enables the manual setting of a bit rate. You can set the bitrate value with BUS<m>:
CXPI:BITRate:VALue.
Suffix:
<m>
.
1..4
Parameters:
<BitrateEnable> ON | OFF
*RST: OFF
BUS<m>:CXPI:BITRate:VALue <Bitrate>
Sets the number of transmitted bits per second. To set this value, you have to enable
the bitrate first with BUS<m>:CXPI:BITRate:ENABle.
Suffix:
<m>
.
1..4
Parameters:
<Bitrate> Range: 1000 to 100000
Increment: 100
*RST: 19200
Default unit: bps
Protocols