Rohde & Schwarz RTE - Trigger

Remote control commands
R&S
®
RTE
1164User Manual 1326.1032.02 ─ 20
Parameters:
<ExternalRef> *RST: 10E+6
Default unit: Hz
Constant frequency of 10E+6 Hz.
Usage: Asynchronous command
18.9 Trigger
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 18.3, "Programming examples", on page 1054
● Basic trigger settings...........................................................................................1165
● Edge trigger.........................................................................................................1168
● Glitch trigger........................................................................................................1171
● Width trigger........................................................................................................1172
● Runt trigger..........................................................................................................1173
● Window trigger.................................................................................................... 1176
● Timeout trigger.................................................................................................... 1178
● Interval trigger..................................................................................................... 1179
● Slew rate trigger.................................................................................................. 1181
● Data2Clock..........................................................................................................1183
● State trigger.........................................................................................................1185
● Pattern trigger......................................................................................................1187
● Serial pattern trigger............................................................................................1190
● TV/Video trigger.................................................................................................. 1192
● Line trigger.......................................................................................................... 1197
● Holdoff.................................................................................................................1197
● Noise Reject........................................................................................................1201
● Trigger sequence................................................................................................ 1204
● Trigger control..................................................................................................... 1206
● Actions on trigger................................................................................................ 1208
● External trigger input...........................................................................................1210
● Acquisition info....................................................................................................1210
Trigger