Waveform generator (Option R&S RTE-B6)
R&S
®
RTE
937User Manual 1326.1032.02 ─ 20
Start frequency
Sets the start frequency of the sweep signal.
Remote command:
WGENerator<m>:SWEep:FSTart on page 1932
Stop freuqency
Sets the stop frequency of the sweep signal.
Remote command:
WGENerator<m>:SWEep[:FEND] on page 1932
Sweep time
Sets the duration of the sweep.
Remote command:
WGENerator<m>:SWEep:TIME on page 1932
15.1.5 Arbitrary
The arbitrary waveform generator allows you to output a user-defined waveform for
testing your devices. You can output a waveform from a file or from the current
R&S RTE reference curve format. Files in *.csv and *.bin formats are supported.
This files must follow a defined structure. You can load *.csv files in an R&S Wave
Gen format (see Content and format of the R&S wave gen *.csv files), Tektronix AFG
format or Keysight WaveGen format.
Setup of the waveform generator
To Next Page
Loading...
