Rohde & Schwarz RTE - Position and Range Settings

Waveform analysis
R&S
®
RTE
282User Manual 1326.1032.02 ─ 20
Remote command:
LAYout:ZOOM:VERTical:RELative:STOP on page 1219
LAYout:ZOOM:VERTical:ABSolute:STOP on page 1218
Full height
Uses the full diagram height for the zoom area. Only horizontal zoom settings can be
changed.
Position coupling
Enables or disables the position coupling of coupled zooms. If position coupling is
enabled and you move one zoom area, the other coupled zoom areas are moved, too,
and keep their distance.
Remote command:
LAYout:ZOOM:POSCoupling on page 1213
Horizontal
Defines whether absolute or relative values are used to specify the x-axis values.
Remote command:
LAYout:ZOOM:HORZ:MODE on page 1213
SEARch:RESDiagram:HORZ:MODE on page 1385
Start / Relative start
Defines the lower limit of the zoom area on the x-axis.
Remote command:
LAYout:ZOOM:HORZ:ABSolute:STARt on page 1214
LAYout:ZOOM:HORZ:RELative:STARt on page 1216
Stop / Relative stop
Defines the upper limit of the zoom area on the x-axis.
Remote command:
LAYout:ZOOM:HORZ:ABSolute:STOP on page 1215
LAYout:ZOOM:HORZ:RELative:STOP on page 1216
7.1.2.3 Position and range settings
In the "Position/Range" tab, you specify the x and y position of center point of the zoom
area plus a range for the x- and y-axes; the area defined by that point and the ranges
is zoomed.
Zoom