Rohde & Schwarz RTE - Predefined Probes

Remote control commands
R&S
®
RTE
1138User Manual 1326.1032.02 ─ 20
PROBe<m>:SETup:TERM:MEASure?
Returns the measured common mode voltage.
Suffix:
<m>
.
1..4
Return values:
<VoltageMeas> Common mode voltage
Range: -100E+24 to 100E+24
Increment: 1E-3
*RST: 0
Default unit: V
Usage: Query only
Asynchronous command
PROBe<m>:SETup:TERM:ADJust
<VoltageAdjust>
Sets the voltage to be used for termination correction.
Suffix:
<m>
.
1..4
Parameters:
<VoltageAdjust> Correction voltage
Range: -100E+24 to 100E+24
Increment: 1E-3
*RST: 0
Default unit: V
Usage: Asynchronous command
18.8.7.6 Predefined probes
TRPRobe:SETup:ATTenuation:DEFProbe.......................................................................1138
PROBe<m>:SETup:ATTenuation:DEFProbe................................................................... 1138
PROBe<m>:SETup:OFFSet:TOMean.............................................................................1139
TRPRobe:SETup:ATTenuation:DEFProbe <SelcPredefPrb>
PROBe<m>:SETup:ATTenuation:DEFProbe <PredefinedProbe>
Selects a predefined probe. These are probes that are not recognized automatically
but the parameters of the probe are known to the instrument.
Acquisition and setup