Rohde & Schwarz RTE - Passive Probes

Remote control commands
R&S
®
RTE
1131User Manual 1326.1032.02 ─ 20
18.8.7.3 Passive probes
TRPRobe:SETup:ATTenuation:MODE............................................................................ 1131
PROBe<m>:SETup:ATTenuation:MODE.........................................................................1131
TRPRobe:SETup:ATTenuation:UNIT.............................................................................. 1131
PROBe<m>:SETup:ATTenuation:UNIT...........................................................................1131
TRPRobe:SETup:ATTenuation:MANual.......................................................................... 1131
PROBe<m>:SETup:ATTenuation:MANual....................................................................... 1131
TRPRobe:SETup:GAIN:MANual.................................................................................... 1132
PROBe<m>:SETup:GAIN:MANual................................................................................. 1132
TRPRobe:SETup:ATTenuation:MODE <AttenuationMode>
PROBe<m>:SETup:ATTenuation:MODE <PrbAttMd>
Set the mode to MANual if the instrument does not detect the probe.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<PrbAttMd> AUTO | MANual
*RST: AUTO
Usage: Asynchronous command
TRPRobe:SETup:ATTenuation:UNIT <AttenuationUnit>
PROBe<m>:SETup:ATTenuation:UNIT <AttenuationUnit>
Sets the unit for the connected probe type if PROBe<m>:SETup:ATTenuation:MODE
on page 1131 is set to MANual.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<AttenuationUnit> V | A | W
Voltage probe (V), current probe (A), power probe (W)
*RST: V
Usage: Asynchronous command
TRPRobe:SETup:ATTenuation:MANual <PrbAttMdManual>
PROBe<m>:SETup:ATTenuation:MANual <ManualAttenuation>
Sets the attenuation for the connected probe if PROBe<m>:SETup:ATTenuation:
MODE on page 1131 is set to MANual.
Suffix:
<m>
.
1..4
Selects the input channel.
Acquisition and setup