Rohde & Schwarz RTE - Flexray Trigger

Protocol analysis
R&S
®
RTE
622User Manual 1326.1032.02 ─ 20
13.7.2 FlexRay trigger
13.7.2.1 FlexRay trigger
Access: [PROTOCOL] > "Trigger" tab > "Source = Serial Bus"
Make sure that:
●
In the [PROTOCOL] > "Decode" tab:
– The correct "Protocol" is selected.
– The data sources of the serial bus are channel signals.
●
In the "Trigger" > "Setup" tab:
– The trigger "Sequence" = "A only".
– The trigger "Source" = "Serial bus".
– The correct "Serial bus" is selected.
Trigger type
Selects the trigger type for FlexRay analysis.
"Start of frame"
Triggers on the first rising edge after the transmission start sequence
(TSS).
FlexRay (option R&S RTE-K4)