Getting started
R&S
®
RTE
59User Manual 1326.1032.02 ─ 20
Connecting a keyboard
The keyboard is detected automatically when it is connected. The default input lan-
guage is English – US.
To configure the keyboard properties:
1. Tap the "Find" icon (magnifier) on the Windows taskbar.
2. Type keybord.
3. Select "Edit language and keyboard options".
Connecting a mouse
The mouse is detected automatically when it is connected. To configure the mouse
properties:
1. Tap the "Find" icon (magnifier) on the Windows taskbar.
2. Type mouse.
3. Select "Mouse settings".
Connecting a printer
When printing a file, the instrument checks whether a printer is connected and turned
on, and whether the appropriate printer driver is installed. If necessary, printer driver
installation is initiated by the Windows system. To install a printer driver:
1. Tap the "Find" icon (magnifier) on the Windows taskbar.
2. Type printer.
3. Select "Printers & scanners".
4. Select "Add a printer or scanner".
3.1.8.2 Connecting an external monitor
You can connect an external monitor or projector to the R&S RTE. The following con-
nectors are available:
●
"MONITOR (DVI-D)" on page 64
Before connecting an external monitor, ensure that the monitor and the R&S RTE are
connected to a ground contact. Otherwise the instrument can be damaged.
After connecting an additional monitor or projector to the instrument, configure it for
usage. The relevant settings are Windows settings but you can configure the displays
directly in the instrument setup.
1. Check the input type of the monitor or projector. Make sure to select the correct
cable. To use a VGA monitor, you need an active DVI-D to VGA adapter.
2. Press the [SETUP] key.
3. Select the "System" tab.
Preparing for use
To Next Page
Loading...
