Rohde & Schwarz RTE - CAN; CAN FD Trigger; Trigger Settings

Protocol analysis
R&S
®
RTE
566User Manual 1326.1032.02 ─ 20
Remote command:
BUS<m>:CAN:T1Segment on page 1491
BUS<m>:CAN:T2Segment on page 1492
BUS<m>:CAN:SAMPlepoint on page 1491
BUS<m>:CAN:JWIDth on page 1492
BUS<m>:CAN:FDATa:T1Segment on page 1491
BUS<m>:CAN:FDATa:T2Segment on page 1492
BUS<m>:CAN:FDATa:SAMPlepoint on page 1491
BUS<m>:CAN:FDATa:JWIDth on page 1492
13.5.3 CAN / CAN FD trigger
The R&S RTE can trigger on various events in a CAN or CAN FD frame. Trigger condi-
tions include start of frame, frame ID, data pattern, or error conditions.
13.5.3.1 Trigger settings
Access: [PROTOCOL] > "Trigger" tab > "Source = Serial Bus"
CAN and CAN FD (option R&S RTE-K3/K9)