Rohde & Schwarz RTE - Mask Test Settings; Test Definition

Mask testing
R&S
®
RTE
424User Manual 1326.1032.02 ─ 20
Remote command:
MTESt:RESult:FRATe? on page 1351
Test result
A test has failed if the number of sample hits or acquisition hits exceeds the limit of
"Violation tolerance" hits.
Remote command:
MTESt:RESult[:RESult]? on page 1349
10.2 Mask test settings
10.2.1 Test definition
Access: [MASKS] > "Test Definition"
The "Test Definition" tab provides all settings for the mask test itself: the waveform to
be tested, pass/fail conditions, and saving/loading the mask definition.
The content of the "Test Definition" tab depends on the selected definition type. If
"Waveform" is selected, the main mask settings can be set directly on the "Test Defini-
tion" tab. For a description of these settings, see "Definition Type" on page 425.
Make sure that the correct "Mask Test" tab is selected on the left side before you enter
the settings.
Remote commands:
●
MTESt:ADD on page 1332
MTESt:REMove on page 1332
Mask test settings