Measurements
R&S
®
RTE
346User Manual 1326.1032.02 ─ 20
3. Enable "Display result lines" or "Display reference levels" option, or both.
The reference levels and intermediate results are displayed in the waveform dia-
gram.
8.2.4.2 Level settings
Access: "Meas" menu > "Reference Level" > "Levels" tab.
On the "Levels" tab, you define how the reference levels are calculated, or you set
them directly.
In automatic reference level mode, the reference levels are always relative values. You
can select one of the predefined sets, or define individual percentage values.
Figure 8-5: Automatic reference level definition
In manual reference level mode, relative and absolute level definitions are possible.
In manual reference level mode with relative level definition, you define the absolute
values of high and low signal levels, and the reference levels as percentages of the
signal amplitude.
Automatic measurements
To Next Page
Loading...
