Rohde & Schwarz RTE - Transient Response

Remote control commands
R&S
®
RTE
1978User Manual 1326.1032.02 ─ 20
Query parameters:
<VoltageMeasType> VOLTage | CURRent
*RST: VOLTage
Return values:
<Result> Statistic result
Usage: Query only
POWer:RIPPle:RESult:STDDev[:ACTual]? [<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:AVG? [<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:EVTCount? [<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:NPEak? [<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:PPEak? [<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:RMS? [<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:STDDev? [<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:WFMCount? [<VoltageMeasType>]
Return the specified statistic result for the standard deviation of the long-term mea-
surement results.
●
[:ACTual]: current measurement result
●
AVG: average of the long-term measurement results
●
EVTCount: number of measurement results in the long-term measurement
●
NPEak: negative peak value of the long-term measurement results
●
PPEak: positive peak value of the long-term measurement results
●
RMS: RMS value of the long-term measurement results
●
STDDev: standard deviation of the long-term measurement results
Query parameters:
<VoltageMeasType> VOLTage | CURRent
*RST: VOLTage
Return values:
<Result> Statistic result
Usage: Query only
18.20.15 Transient response
This measurement is a single shot measurement. To start the measurement, use the
RUNS command.
Progragramming example: Chapter 18.3.7.2, "Transient response measurement",
on page 1071
POWer:TRANsient:AUToscale.......................................................................................1979
POWer:TRANsient:EXECute.........................................................................................1979
POWer:TRANsient:FREQuency.....................................................................................1979
POWer:TRANsient:HYSTeresis..................................................................................... 1979
POWer:TRANsient:INPut.............................................................................................. 1979
Power analysis (option R&S
RTE-K31)