Getting started
R&S
®
RTE
62User Manual 1326.1032.02 ─ 20
The input connectors are provided with a special Rohde & Schwarz active probe inter-
face, and they are BNC compatible. Thus, the instrument can automatically detect pas-
sive probes with standard BNC connector and active Rohde & Schwarz probes having
the Rohde & Schwarz probe interface.
The input impedance is selectable, the values are 50 Ω and 1 MΩ.
The maximum input voltage is 200 V peak, 150 V RMS at 1 MΩ input impedance and
5 V RMS at 50 Ω input impedance.
For the external trigger input, the maximum input voltage is 30 V RMS at 1 MΩ input
impedance and 5 V RMS at 50 Ω input impedance.
3.2.1.2 Other front panel connectors
Besides the input connectors, the instrument has USB connectors and probe compen-
sation connectors at the front panel.
[USB]
Two USB type A connectors that comply with standard USB 2.0. They are used to con-
nect devices like keyboard, mouse and USB flash drive.
Note: Electromagnetic interference (EMI) can affect the measurement results. To avoid
any impact, do not use USB connecting cables exceeding 1 m.
PROBE COMPENSATION
Probe compensation terminal to support adjustment of passive probes to the oscillo-
scope channel.
Protective earth conductor, 4 mm banana jack to connect ground of
DUT and test fixtures, and wrist strap.
Square wave signal for probe compensation, 1 kHz and 1 V
pp
.
Ground connector for probes.
3.2.2 Rear panel
Figure 3-2 shows the rear panel of the R&S RTE with its connectors.
Instrument tour
To Next Page
Loading...
