Getting started
R&S
®
RTE
63User Manual 1326.1032.02 ─ 20
Figure 3-2: Rear panel view of R&S
RTE
1 = AC power supply connector and main power switch
2 = USB connectors
3 = LAN connector
4 = DVI-D connector for external monitor
5 = Optional exchangeable solid state disk (SSD), option R&S RTE-B18
6 = External trigger output
7 = Reference input/output
8 = Slot for hardware option: mixed signal option R&S RTE-B1 (shown in picture), or waveform generator
R&S RTE-B6, or GPIB connector R&S RTE-B10)
9 = Kensington lock slot to secure the instrument against theft
10 = Lugs to attach the accessory bag
AC power supply connector and main power switch
Connection to the AC power line. The R&S RTE can be used with different AC power
voltages and adapts itself automatically to it. The nominal voltage and frequency
ranges are displayed on the rear panel and quoted in the data sheet.
If grounding is not ensured by the mains system, ground the oscilloscope using the
protective earth conductor on the front panel and an appropriate cable.
When you power up the instrument, be sure to comply with the warm-up phase speci-
fied in the data sheet before you start measurements.
See also: Chapter 3.1.6, "Connecting to power", on page 56.
Instrument tour
To Next Page
Loading...
