Rohde & Schwarz RTE - Width Trigger

Remote control commands
R&S
®
RTE
1914User Manual 1326.1032.02 ─ 20
TRIGger<m>:PARallel:EDGE:SLOPe <Slope>
Defines the edge - the state transition - of the signal to trigger on a single digital chan-
nel (a logic bit), or a logical combination of digital channels.
Parameters:
<Slope> POSitive | NEGative | EITHer
*RST: POSitive
Usage: Asynchronous command
18.18.4.3
Width trigger
See also:
●
TRIGger<m>:PARallel:WIDTh:EXPRession[:DEFine] on page 1913
TRIGger<m>:PARallel:WIDTh:POLarity..........................................................................1914
TRIGger<m>:PARallel:WIDTh:RANGe........................................................................... 1914
TRIGger<m>:PARallel:WIDTh:WIDTh............................................................................ 1915
TRIGger<m>:PARallel:WIDTh:DELTa.............................................................................1915
TRIGger<m>:PARallel:WIDTh:POLarity <Polarity>
Sets the polarity of a pulse. When triggering on a positive pulse, the trigger event
occurs on the high to low transition of the pulse if the timing condition is true. When
triggering on a negative pulse, the trigger event occurs on the low to high transition of
the pulse if the timing condition is true.
Parameters:
<Polarity> POSitive | NEGative | EITHer
*RST: POSitive
Usage: Asynchronous command
TRIGger<m>:PARallel:WIDTh:RANGe <RangeMode>
Selects how the range of a pulse width is defined:
Parameters:
<RangeMode> WITHin | OUTSide | SHORter | LONGer
WITHin | OUTSide
Pulses inside or outside a given time range. The time range
Width
± Delta is defined by TRIGger<m>:PARallel:WIDTh:
WIDTh and TRIGger<m>:PARallel:WIDTh:DELTa.
SHORter | LONGer
Pulses shorter or longer than a given width defined by
TRIGger<m>:PARallel:WIDTh:WIDTh
*RST: WITHin
Usage: Asynchronous command
Mixed signal option (MSO, R&S RTE-B1)