Rohde & Schwarz RTE - Configuring the Search Setup; Frequency Marker Search

Search functions
R&S
®
RTE
459User Manual 1326.1032.02 ─ 20
Remote command:
SEARch:TRIGger:PATTern:A[:ENABle] on page 1372
SEARch:TRIGger:PATTern:A:LOGic on page 1372
SEARch:TRIGger:PATTern:AB:LOGic on page 1373
SEARch:TRIGger:PATTern:ABCD:LOGic on page 1373
Timing condition: Mode, Range, Time, Width, ±Delta
Additional time limitation to the pattern, see "Additional settings: Timing" on page 257.
Remote command:
SEARch:TRIGger:PATTern:MODE on page 1373
SEARch:TRIGger:PATTern:TIMeout:MODE on page 1374
SEARch:TRIGger:PATTern:TIMeout[:TIME] on page 1374
SEARch:TRIGger:PATTern:WIDTh:RANGe on page 1374
SEARch:TRIGger:PATTern:WIDTh[:WIDTh] on page 1375
SEARch:TRIGger:PATTern:WIDTh:DELTa on page 1375
11.2.3 Frequency marker search
When you start a search on a spectrum, a frequency marker search is performed to
detect peaks in a spectrum. You can define which peaks the instrument finds by defin-
ing the noise reject settings.
Threshold
See "Threshold" on page 332.
Peak excursion
See "Peak excursion" on page 332.
11.2.4 Configuring the search setup
There are several ways to create a search:
●
Creating a simple default search using the toolbar icon. This method is not availa-
ble for search on serial buses.
●
Setting up a search using the dialog box.
To perform a simple search
1. If more than one waveform is in the diagram, select the waveform to be searched
for by tapping it in the diagram.
2. Select the "Search" icon on the toolbar.
Search setup