Waveform analysis
R&S
®
RTE
316User Manual 1326.1032.02 ─ 20
7.4.3 Using history
You can access the history waveforms in two ways:
●
Display a particular acquisition.
●
Replay all or a part of the saved waveforms to track the signal run.
Furthermore, you can export history data to a file.
●
"To open the history and get information" on page 316
●
"To display a particular acquisition" on page 316
●
"To replay history waveforms" on page 317
●
"To exit the history" on page 317
●
"To save the history data" on page 317
To open the history and get information
1. Press the [HISTORY] key on the front panel. A running acquisition is stopped, the
history mode is enabled and the quick-access "History" dialog box is displayed.
The [HISTORY] key is illuminated as long as the history mode is active.
2. Open the full configuration dialog box:
●
Tap the
icon.
● Press the [HISTORY] key again.
● On the "Display" menu, tap "History setup".
3. In the "History" configuration dialog box, select the "Information" tab to see how
many history waveforms are saved, and how many can be saved as maximum.
To display a particular acquisition
1. In the quick-access "History" dialog box, enter the number of the required acquisi-
tion in the "Current index" field. The newest acquisition always has the index "0",
older acquisitions have a negative index
2. Tap "Play" to start.
Alternatively, you can configure and start the history display from the "History" configu-
ration dialog box:
1. Open the "History" configuration dialog box and select the "Viewer" tab.
2. If the history mode is off (the [HISTORY] key is not illuminated), select "Show his-
tory".
The quick-access dialog box is displayed.
3. Drag the slider to the required acquisition. The current number is shown in the
"Current index" field.
Alternatively, enter the number of the required acquisition in the "Current index"
field.
4. Tap "Play" to start.
History
To Next Page
Loading...
