Instrument setup
R&S
®
RTE
153User Manual 1326.1032.02 ─ 20
Remote command:
●
DISPlay:CLR on page 1105
4.4.3 Adjusting the display
You can adjust the appearance of several display elements:
●
Diagram name, see Chapter 4.4.3.1, "Changing the diagram name", on page 153.
●
Waveform colors, see Chapter 4.4.3.2, "Changing waveform colors", on page 153.
●
Icons on the toolbar, see Chapter 3.4.7.2, "Configuring the toolbar", on page 119.
●
Font size and transparency of dialog boxes and result boxes, see Chapter 4.4.3.3,
"Configuring the appearance of dialog and result boxes", on page 155.
●
Behaviour and position of the signal bar, see Chapter 3.4.6, "Using the signal bar",
on page 116.
4.4.3.1 Changing the diagram name
The diagram name is shown on the diagram tab.
► Double-tap the diagram tab name. The on-screen keyboard opens to enter the new
name.
In remote operation, useDISPlay:DIAGram:REName.
4.4.3.2 Changing waveform colors
For each waveform, you can set a waveform color, or you define a color table that
specifies which waveform points are displayed in which color. You can use one of the
default color tables, or define your own table according to your needs. You can also
edit the default color tables.
After you define a color table, you must assign it to the waveform it is to be used for,
and enable its use.
The exact mapping of the cumulative value occurrences according to the assigned
color table is guaranteed only if the intensity is set to 50%. All other intensity values
falsify the mapping but may improve the visibility of the signal.
See also: "Intensity" on page 145.
For details on signal color settings, see Chapter 4.4.2.2, "Color tables", on page 146.
To change a waveform color
1. On the "Display" menu, tap "Signal Colors / Persistence".
2. Under "Color table assignment", select the waveform for which you want to change
the color.
Display configuration
To Next Page
Loading...
