Rohde & Schwarz RTE - Basic FFT; Spectrum Analysis

Remote control commands
R&S
®
RTE
1315User Manual 1326.1032.02 ─ 20
Return values:
<SignalHigh> Range: -100E+24 to 100E+24
*RST: 0
Usage: Query only
Asynchronous command
18.13 Spectrum analysis
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 18.3, "Programming examples", on page 1054
18.13.1 Basic FFT
CALCulate:MATH<m>:FFT:LOGScale............................................................................1316
CALCulate:MATH<m>:FFT:STARt..................................................................................1316
CALCulate:MATH<m>:FFT:STOP.................................................................................. 1316
CALCulate:MATH<m>:FFT:CFRequency........................................................................1317
CALCulate:MATH<m>:FFT:FULLspan............................................................................1317
CALCulate:MATH<m>:FFT:SPAN.................................................................................. 1317
CALCulate:MATH<m>:FFT:BANDwidth[:RESolution]:ADJusted?.......................................1318
CALCulate:MATH<m>:FFT:BANDwidth[:RESolution]:AUTO..............................................1318
CALCulate:MATH<m>:FFT:BANDwidth[:RESolution]:RATio..............................................1318
CALCulate:MATH<m>:FFT:BANDwidth[:RESolution][:VALue]........................................... 1319
CALCulate:MATH<m>:FFT:WINDow:TYPE.....................................................................1319
CALCulate:MATH<m>:FFT:FRAMe:ARIThmetics............................................................ 1320
CALCulate:MATH<m>:FFT:FRAMe:COVerage?.............................................................. 1320
CALCulate:MATH<m>:FFT:FRAMe:MAXCount............................................................... 1321
CALCulate:MATH<m>:FFT:FRAMe:OFACtor.................................................................. 1321
CALCulate:MATH<m>:FFT:GATE:COUPling...................................................................1321
TIMebase:RACTime?................................................................................................... 1322
CALCulate:MATH<m>:FFT:GATE:ABSolute:STARt..........................................................1322
CALCulate:MATH<m>:FFT:GATE:ABSolute:STOP.......................................................... 1323
CALCulate:MATH<m>:FFT:GATE:MODE........................................................................1323
CALCulate:MATH<m>:FFT:GATE:RELative:STARt.......................................................... 1323
CALCulate:MATH<m>:FFT:GATE:RELative:STOP...........................................................1323
CALCulate:MATH<m>:FFT:GATE:ZCOupling..................................................................1324
CALCulate:MATH<m>:FFT:GATE[:STATe]...................................................................... 1324
Spectrum analysis