Rohde & Schwarz RTE - Page 1316

Remote control commands
R&S
®
RTE
1316User Manual 1326.1032.02 ─ 20
CALCulate:MATH<m>:FFT:MAGNitude:LEVel.................................................................1324
CALCulate:MATH<m>:FFT:MAGNitude:RANGe.............................................................. 1325
CALCulate:MATH<m>:FFT:MAGNitude:SCALe...............................................................1325
CALCulate:MATH<m>:FFT:PHASe:SCALe..................................................................... 1326
CALCulate:MATH<m>:FFT:PHASe:SUPPression............................................................ 1326
CALCulate:MATH<m>:FFT:PHASe:THReshold............................................................... 1326
CALCulate:MATH<m>:FFT:PHASe:UNWRap..................................................................1327
CALCulate:MATH<m>:FFT:COUPled:WITH<1..8>...........................................................1327
CALCulate:MATH<m>:FFT:LOGScale <XAxisMode>
Defines the scaling method for the frequency (x-)axis of the spectrogram.
This command is only available if option R&S RTE-K18 is installed.
Suffix:
<m>
.
1..8
Parameters:
<XAxisMode> LIN | LOG
LOG
Logarithmic scaling
LIN
Linear scaling
*RST: LIN
Usage: Asynchronous command
CALCulate:MATH<m>:FFT:STARt <StartFreq>
Defines the start frequency of the displayed frequency span.
Suffix:
<m>
.
1..8
math waveform
Parameters:
<StartFreq> start frequency
Range: 0 to 5E+9
Increment: 1
*RST: 2E+9
Default unit: Hz
Usage: Asynchronous command
CALCulate:MATH<m>:FFT:STOP <StopFreq>
Defines the stop frequency of the displayed frequency span.
Suffix:
<m>
.
1..8
math waveform
Spectrum analysis