Rohde & Schwarz RTE - Setup for Passive Probes

Acquisition and waveform setup
R&S
®
RTE
200User Manual 1326.1032.02 ─ 20
TRPRobe:PMETer:RESults:NEGative? on page 1130
TRPRobe:PMETer:RESults:DIFFerential? on page 1129
TRPRobe:PMETer:RESults:COMMon? on page 1129
5.5.3 Setup for passive probes
Passive probes are the most widely used probes for oscilloscope measurements. Pas-
sive probes require compensation.
Figure 5-8: Probe setup for passive probe R&S RT-ZP10
The following shared probe settings are available:
●
"Type, Name, Bandwidth" on page 195
●
"Detect AutoZero, Use AutoZero" on page 195
●
"External attenuation: Scale, Attenuation" on page 196
If a passive probe is connected, the probe attenuation is read out and shown in the
"Setup" tab:
●
"Probe unit, Auto attenuation" on page 197
If you need to change the unit or attenuation, change the "Mode" to "Manual" and enter
the correct values.
Mode........................................................................................................................... 200
Vertical unit, Attenuation, Gain....................................................................................201
Mode
Defines how the attenuation of a passive probe is set.
"Auto"
The instrument uses the values that are read out from the probe.
"Manual"
You can define the attenuation unit and value.
See: "Vertical unit, Attenuation, Gain" on page 201
Remote command:
PROBe<m>:SETup:ATTenuation:MODE on page 1131
TRPRobe:SETup:ATTenuation:MODE on page 1131 (trigger input)
Probes