Rohde & Schwarz RTE - SENT Search Settings

Remote control commands
R&S
®
RTE
1719User Manual 1326.1032.02 ─ 20
BUS<m>:SENT:RDSL <RessDispSel>
Selects the results to be displayed.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<RessDispSel> TRSQ | SMSG | ALL
Transmission sequence, serial messages or all.
*RST: ALL
18.17.14.4
SENT search settings
In search setup commands, you have to specify the <SearchName> parameter. It is a
string parameter that contains the search definition name. The commands are similar
to SENT trigger commands.
SEARch:TRIGger:SENT:CALibration..............................................................................1719
SEARch:TRIGger:SENT:TRANsmission......................................................................... 1720
SEARch:TRIGger:SENT:SMSG.....................................................................................1720
SEARch:TRIGger:SENT:ERRor.....................................................................................1720
SEARch:TRIGger:SENT:TTYPe.....................................................................................1721
SEARch:TRIGger:SENT:STATus....................................................................................1721
SEARch:TRIGger:SENT:TDCN......................................................................................1722
SEARch:TRIGger:SENT:TDMN..................................................................................... 1722
SEARch:TRIGger:SENT:TDMX..................................................................................... 1722
SEARch:TRIGger:SENT:STYPe.................................................................................... 1723
SEARch:TRIGger:SENT:SIDType.................................................................................. 1723
SEARch:TRIGger:SENT:SICN.......................................................................................1723
SEARch:TRIGger:SENT:SIMN.......................................................................................1724
SEARch:TRIGger:SENT:SIMX.......................................................................................1724
SEARch:TRIGger:SENT:SDCN..................................................................................... 1724
SEARch:TRIGger:SENT:SDMN.....................................................................................1725
SEARch:TRIGger:SENT:SDMX..................................................................................... 1725
SEARch:TRIGger:SENT:PULSeerror..............................................................................1725
SEARch:TRIGger:SENT:PPERioderror...........................................................................1726
SEARch:TRIGger:SENT:IRFLength............................................................................... 1726
SEARch:TRIGger:SENT:FORMerror.............................................................................. 1726
SEARch:TRIGger:SENT:CRCerror.................................................................................1726
SEARch:TRIGger:SENT:CALibration <SearchName>,<CalSyncPulse>
SEARch:TRIGger:SENT:CALibration? <SearchName>
Enables the search for the Calibration/Synchronization pulse.
Parameters:
<CalSyncPulse> ON | OFF
*RST: OFF
Protocols