Rohde & Schwarz RTE - Timeout Search Conditions; Width Search Conditions

Remote control commands
R&S
®
RTE
1364User Manual 1326.1032.02 ─ 20
18.15.8 Timeout search conditions
Trigger level setting: SEARch:TRIGger:LEVel[:VALue] on page 1355
SEARch:TRIGger:TIMeout:RANGe................................................................................1364
SEARch:TRIGger:TIMeout:TIME................................................................................... 1364
SEARch:TRIGger:TIMeout:RANGe <SearchName>,<TimeoutMode>
SEARch:TRIGger:TIMeout:RANGe? <SearchName>
Selects the relation of the signal level to the trigger level:
Parameters:
<TimeoutMode> HIGH | LOW | EITHer
HIGH
The signal level stays above the trigger level.
LOW
The signal level stays below the trigger level.
EITHer
The signal level stays above or below the trigger level.
*RST: HIGH
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
SEARch:TRIGger:TIMeout:TIME <SearchName>,<Time>
SEARch:TRIGger:TIMeout:TIME? <SearchName>
Defines the time limit for the timeout at which the instrument triggers.
Parameters:
<Time> Range: 100E-12 to 864
Increment: 100E-9
*RST: 100E-9
Default unit: s
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
18.15.9 Width search conditions
Trigger level setting: SEARch:TRIGger:LEVel[:VALue] on page 1355
SEARch:TRIGger:WIDTh:DELTa................................................................................... 1365
SEARch:TRIGger:WIDTh:POLarity................................................................................ 1365
SEARch:TRIGger:WIDTh:RANGe..................................................................................1365
SEARch:TRIGger:WIDTh:WIDTh...................................................................................1366
Search