Rohde & Schwarz RTE - Function Generator

Waveform generator (Option R&S RTE-B6)
R&S
®
RTE
926User Manual 1326.1032.02 ─ 20
●
Chapter 15.1.5, "Arbitrary", on page 937
Remote command:
WGENerator<m>:SOURce on page 1923
Copy settings from Gen1/Gen2
Copies all settings from Gen1/Gen2 and applies them to Gen2/Gen1.
Remote command:
WGENerator<m>:ACOPy on page 1923
Preset Gen1/Gen2/Patt Gen
Sets the parameters of the generator to their default values. The settings of the gener-
ators are not affected by an instrument preset.They are also not stored in the user-
defined preset.
Remote command:
WGENerator<m>:PRESet on page 1923
PGENerator:PRESet on page 1937
Message
Displays relevant messages concerning the coupling and sync settings.
15.1.2 Function generator
The R&S RTE function generator can generate input signals during testing. These sig-
nals can be used, for example, when testing circuits.
Function type
Selects the type of waveform to be generated for the function generator.
Setup of the waveform generator