Rohde & Schwarz RTE - Modulation Analysis Settings

Power analysis (option R&S RTE-K31)
R&S
®
RTE
983User Manual 1326.1032.02 ─ 20
16.4.1.3 Modulation analysis settings
In the "Channels" tab, you set the current source and the voltage source, see also:
Chapter 16.2.1, "Channels tab", on page 965.
In the "Settings" tab, you configure the modulation analysis parameters and display
settings.
Source
Selects the source for the measurement.
Remote command:
POWer:MODulation:SOURce on page 1959
Type
Selects the type of signal flow for the measurement
"Continuous"
The measurement is running continuously.
"Turn on"
The measurement runs once when the DUT is turned on.
Remote command:
POWer:MODulation:TYPE on page 1959
Display Histogram
Available only for "Type" > "Continuous".
Enables the display of two histograms after the measurement is executed. The histo-
grams show the density distribution of the measurement results in dependence of the
frequency/ duty cycle in a graphic. Thus they illustrate the statistics of the measure-
ments.
Remote command:
POWer:MODulation:DHIStogram on page 1958
Optimize scaling
Selects the scaling for the display of the results.
Control loop