Rohde & Schwarz RTE - Page 1958

Remote control commands
R&S
®
RTE
1958User Manual 1326.1032.02 ─ 20
POWer:MODulation:RESult:WFMCount?........................................................................1958
POWer:MODulation:SOURce........................................................................................1959
POWer:MODulation:TYPE............................................................................................ 1959
POWer:MODulation:AUTO <Autoscale>
Selects the scaling for the display of the results.
Parameters:
<Autoscale> AUTO | MANUAL
*RST: MANUAL
POWer:MODulation:DHIStogram <DispHistg>
Activates or deactivates the display of a histogram.
Parameters:
<DispHistg> ON | OFF
*RST: ON
POWer:MODulation:EXECute
Starts the modulation analysis measurement.
Usage:
Event
Asynchronous command
POWer:MODulation:REPort:ADD
Adds the result to the report list.
Usage:
Event
POWer:MODulation:RESult:ACTual? <MeasType>
POWer:MODulation:RESult:AVG? <MeasType>
POWer:MODulation:RESult:EVTCount? <MeasType>
POWer:MODulation:RESult:NPEak? <MeasType>
POWer:MODulation:RESult:PPEak? <MeasType>
POWer:MODulation:RESult:RMS? <MeasType>
POWer:MODulation:RESult:STDDev? <MeasType>
POWer:MODulation:RESult:WFMCount? <MeasType>
Return the specified statistic result of the specified measurement type.
●
[:ACTual]: current measurement result
●
AVG: average of the long-term measurement results
●
EVTCount: number of measurement results in the long-term measurement
●
NPEak: negative peak value of the long-term measurement results
●
PPEak: positive peak value of the long-term measurement results
Power analysis (option R&S
RTE-K31)