Rohde & Schwarz RTE - External Trigger Setup

Triggers
R&S
®
RTE
275User Manual 1326.1032.02 ─ 20
●
TRPRobe:SETup:ATTenuation:MANual on page 1131
●
TRPRobe:SETup:ATTenuation:MODE on page 1131
●
TRPRobe:SETup:ATTenuation:UNIT on page 1131
●
TRPRobe:SETup:ATTenuation[:AUTO]? on page 1125
●
TRPRobe:SETup:NAME? on page 1124
●
TRPRobe:SETup:BANDwidth? on page 1125
●
TRPRobe:SETup:CMOFfset on page 1132
●
TRPRobe:SETup:GAIN:MANual on page 1132
●
TRPRobe:SETup:ZAXV on page 1133
R&S ProbeMeter: remote commands:
●
TRPRobe:SETup:DISPlaydiff on page 1128
●
TRPRobe:PMETer:VISibility on page 1128
●
TRPRobe:PMETer:RESults:COMMon? on page 1129
●
TRPRobe:PMETer:RESults:DIFFerential? on page 1129
●
TRPRobe:PMETer:RESults:NEGative? on page 1130
●
TRPRobe:PMETer:RESults:POSitive? on page 1130
●
TRPRobe:PMETer:RESults:SINGle? on page 1129
Probe attributes: remote commands
●
TRPRobe:ID:PRDate? on page 1141
●
TRPRobe:ID:SRNumber? on page 1142
●
TRPRobe:ID:SWVersion? on page 1141
●
TRPRobe:SETup:CAPacitance? on page 1142
●
TRPRobe:SETup:IMPedance? on page 1142
6.8.2 External trigger setup
Access: [TRIGGER] > "Setup" tab > "Source = Extern"
External trigger signals, which are connected to the external trigger input, can be trig-
gered with an edge trigger. The "Find level" function is not available for external trigger
signals.
External trigger input