Rohde & Schwarz RTE - Mask Display

Remote control commands
R&S
®
RTE
1346User Manual 1326.1032.02 ─ 20
Usage: Asynchronous command
18.14.5 Mask display
MTESt:LABel...............................................................................................................1346
MTESt:REName.......................................................................................................... 1346
MTESt:HIGHlight:INFinite............................................................................................. 1346
MTESt:HIGHlight:STATe............................................................................................... 1347
MTESt:HIGHlight:TIME.................................................................................................1347
MTESt:COLor:UNMatch................................................................................................1347
MTESt:COLor:MATCh.................................................................................................. 1347
MTESt:COLor:BORDer.................................................................................................1348
MTESt:COLor:INTerior..................................................................................................1348
MTESt:LABel <LabelState>
Switches the display of the mask test name on or off.
To change the name of the mask test, use MTESt:REName on page 1346.
Parameters:
<LabelState> ON | OFF
*RST: ON
Usage: Asynchronous command
MTESt:REName <MaskTestName>, <NewName>
MTESt:REName? <MaskTestName>
Changes the name of the mask test.
Parameters:
<NewName> String with the new mask test name.
Parameters for setting and query:
<MaskTestName> String with the existing mask test name.
MTESt:HIGHlight:INFinite <State>
If ON, the mask hits are highlighted for an unlimited period of time.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
Mask testing