Acquisition and waveform setup
R&S
®
RTE
221User Manual 1326.1032.02 ─ 20
Remote command:
ZVC:BANDwidth on page 1144
Resolution coupled
Sets the resolution of all R&S RT-ZVC channels.
"On"
The resolution of the analog channels is applied to R&S RT-ZVC
channels. The signal is automatically interpolated or decimated to get
the analog resolution.
"Off"
The resolution of R&S RT-ZVC channels is set in a way so that the
record length of the waveforms is minimum 1000 samples.
Remote command:
ZVC:RESCoupled on page 1146
5.6.1.2 Probes
Access: "Vertical" menu > "ZVC Multi-Channel Probe"> "Probes" tab
Software version
Displays the software version of the probe.
Remote command:
ZVC:Z<m>:ID:SWVersion? on page 1154
Name
Displays the name of the probe.
Remote command:
ZVC:Z<m>:ID:NAME? on page 1153
Serial no
Displays the serial number of the probe.
Remote command:
ZVC:Z<m>:ID:SRNumber? on page 1154
R&S
RT-ZVC probe
To Next Page
Loading...
