Waveform generator (Option R&S RTE-B6)
R&S
®
RTE
936User Manual 1326.1032.02 ─ 20
Frequency 1
Sets the frequency of the first signal in FSK modulated signal.
Remote command:
WGENerator<m>:MODulation:FSK:FONE on page 1929
Frequency 2
Sets the frequency of the second signal in FSK modulated signal.
Remote command:
WGENerator<m>:MODulation:FSK:FTWO on page 1930
Hop rate
Sets the hop rate, the frequency at which signal switches between Frequency 1 and
Frequency 2.
Remote command:
WGENerator<m>:MODulation:FSK[:RATE] on page 1930
15.1.4 Sweep
In the sweep mode, the R&S RTE generates a signal whose frequency gradually
changes from the Start frequency to the Stop freuqency for a certain Sweep time.
Setup of the waveform generator
To Next Page
Loading...
