Rohde & Schwarz RTE - Cursor Results

Remote control commands
R&S
®
RTE
1245User Manual 1326.1032.02 ─ 20
VLRHombus
The cursors are displayed only as vertical lines. The intersec-
tions of the cursors with the waveforms are displayed by rhom-
bus-shaped points.
RHOMbus
The intersections of the cursors with the waveforms are dis-
played by rhombus-shaped points.
*RST: LINes
Usage: Asynchronous command
CURSor<m>:LABel
<ShowLabel>
Shows the cursor labels in the diagram.
Suffix:
<m>
.
1 | 2
Selects the cursor set.
Parameters:
<ShowLabel> ON | OFF
*RST: ON
Usage: Asynchronous command
CURSor<m>:SIAD <ShwInAllDiags>
Shows the enabled cursor measurements in all active diagrams of the same domain
(time/ spectrum).
Suffix:
<m>
.
1..*
The suffix is irrelevant. All cursor measurements are affected.
Parameters:
<ShowInAllDiagr> ON | OFF
*RST: ON
Usage: Asynchronous command
18.11.2 Cursor results
DISPlay:RESultboxes:CUPosition..................................................................................1246
CURSor<m>:XDELta[:VALue]?......................................................................................1246
CURSor<m>:XDELta:INVerse?..................................................................................... 1246
CURSor<m>:YDELta[:VALue]?......................................................................................1246
CURSor<m>:YDELta:SLOPe........................................................................................ 1247
Cursor measurements